The metal material spring (dome) is made of stainless steel plate, and the dome can be made into two-layer, single-sided paper stickers, full-page stickers, which enhances the actual effect and is conducive to quick assembly. It can accurately locate the conductive parts on the PCB board.

The basic dome pieces are generally waist-shaped, ring-shaped, cross-shaped, triangular, square, and the diameter and width are determined by your requirements. As long as you give engineering drawings, we will give you a service project of completely free samples. The diameter of the pot slices is generally 3mm to 20mm, and the range is generally 100gf to 600gf, and the range can be increased to 6000gf if there are special needs outpatient requirements (made of special outpatient materials). According to a certain order, put together a plurality of pot pieces, and use PET tape to glue them together, which has the advantages of convenient assembly and accurate positioning.

Each dome paper pasted on the dome paper and the conductive parts on the PCB (mostly located on the top of the fingers of the metal springs on the pcb circuit board), the spring management center will produce a bump, when When the finger is pressed, the dome is concave to form a channel. The dome paper stickers fix each dome piece above the conductive part, and it is not easy to shift the part due to the operator pressing too much. Next, the dome paper sticker has a double-layer structure, and the operator presses it down. There is a very comfortable feeling, and it is not easy to feel hard. For the selection of the material of the dome, everyone clearly understands that the dome is made of stainless steel, but the raw material is not special. For example, the functions of SUS 301 and SUS 304 are different. The stainless steel raw materials used for dome pieces also have SUS 430. The main functions of the three raw materials are also different.

SUS301 has good ductility, high carbon content and good strength. However, there is a certain lack of plasticity, and it is not suitable for industrial products. If it is used in mobile phones, computer keyboards and other commodities, SUS301 is the best choice. SUS301 has better conductivity and stable performance than SUS304 and SUS430, but has poor ductility. Such raw materials should not be used in products that must be malleable, such as mobile phones. SUS304 is suitable for immediate welding on the PCB board. SUS430 is not common, contains a lot of residues, and the metal material is not pure, resulting in unstable strength. There are three key materials for the dome sheet. For special needs, SUS301, SUS304, and SUS43 can be added to SUS301, SUS304, and SUS43 without adding other materials to increase hardness, conductivity, ductility, etc.